Honeywell 5800SS1—Battery Replacement

When it is time to replace the battery in your shock sensor, you will see an alert on your system panel, as well as a notification in the Brinks Home™ Mobile App. Follow the instructions below to replace your battery and clear the alert from your system. Batteries can be purchased at your local hardware, mass retailer, or battery store. You may also order it online here or at your preferred online retailer.

Step-by-Step Instructions:

1. Remove the battery cover by inserting a flat head screwdriver into the small cutout on the side of the sensor, and twist to remove the cover.



2. Remove the current battery.



3. Insert a new CR2 3-volt lithium battery.


4. Place the cover back on the sensor, then press the cover to snap it shut.

Check if the low battery status has cleared from your panel or app or go to the following link for further instructions on clearing the error from the panel memory: GC2 GoControl - Silence Reset Alarm.