ADC-V515 Indoor Video Camera Guide

Summary: The ADC-V515 Indoor Camera offers advanced features like 1080p video resolution, HDR recording, and two-way audio. This guide provides specifications, installation steps, troubleshooting advice, and an LED reference guide to ensure optimal performance.

Specifications

• 1920 x 1080p video resolution
• HDR High Dynamic Range video recording
• 15' night vision range
• 110° field of view
• Two-way talk/listen
• Wi-Fi 802.11 b/g/n, 2.4 GHz
• Operating temperature: 32°F to 104°F

Features

• 110° field of view
• High Dynamic Range (HDR)
• Two-way audio
• 2.4 GHz Wi-Fi connection
• Compatible with the Brinks Home™ Mobile App
• Continuous local recording
• Smart view for onboard recording
• Stream video recorder integration
• Video analytics, motion detection, and cloud storage for sensor-triggered clips

Factory Default

Warning: Resetting the camera erases all settings and requires it to be re-added to your account.

1. Press and hold the reset/WPS button located on the back of the camera.
2. Release the button when the LED flashes green and red (approximately 15 seconds).

Wi-Fi Setup by WPS Enrollment

Note: Perform these steps near the camera's final location to ensure a sufficient Wi-Fi signal before mounting.

1. Connect the camera’s AC power adapter to a non-switched outlet.
2. Press and hold the reset button until the LED blinks blue (about 3 seconds), then release.
3. Activate WPS mode on your router. The camera will connect to the Wi-Fi network.
4. The LED will turn solid green when the connection is complete.

Wi-Fi Setup by AP Mode

Note: Perform these steps near the camera's final location to ensure a sufficient Wi-Fi signal before mounting.

1. Connect the camera’s AC power adapter to a non-switched outlet.
2. If the LED does not blink white after two minutes, press and hold the reset button until it blinks white (about 6 seconds).
3. On a device, connect to the Wi-Fi network "ADC-V515 (XX:XX:XX)," where XX:XX:XX matches the camera's MAC address (found on the camera or packaging).
4. Open a browser and go to http://v515install, and follow the on-screen instructions to connect the camera to Wi-Fi.
5. The LED will turn solid green when the connection is complete.

Add Camera Using the Brinks Home™ App Website

1. Log in to the Brinks Home App on a desktop browser and press Video.

   

2. Select Settings.

   

3. Scroll to the bottom of the page and select Add Video Device.

   

4. The camera should be detected. Enter the camera name, then select Install.

   

5. Wait a few minutes for the camera to configure.

   

6. Once configured, select Live View to access the camera feed.

   

Add Camera Using the Brinks Home™ Mobile App

1. Log in to the Brinks Home Mobile App, and press Video.

   

2. Select Settings by pressing the gear icon in the upper right-hand corner.

   

3. Select Add Video Device, then select your compatible device type.

   

4. The camera should be detected. Enter the camera name, then select Next.

   

5. Wait for the camera to configure.

   

6. Once configured, select Live View to access the camera feed.

   

LED Reference Guide

• Off: No power
• Flashing red: Power on, camera booting
• Flashing green: Local network connection
• Solid green: Internet and Alarm.com connection
• Flashing blue: WPS enrollment mode enabled
• Flashing white: Wi-Fi access point mode
• Solid red: No local or Internet connection