Lynx Plus - System or Sensor Trouble
1. Lynx Plus beeps rapidly when a trouble exists, press * STATUS to view
2. Enter User Code then press DISARM to reset, trouble will not reset until trouble ends
Possible troubles
- bF = Not communicating with cellular module
- CC = Remote access or download in progress, this is not a trouble
- Check 01 to 41 = Sensor supervisory trouble, tamper or failure
- Comm Fail = Failure to communicate to Brinks Home Security
- d1 = Standby Panel powering up or disabled by downloading
- EA = Exit Alarm Door was left open after arming, this is not a trouble
- Fault 01 to 41 = Sensor open, this is not a trouble
- Fault 90 = RF Jam or interference
- Fault 103 = Not communicating with cellular module
- FC = Fail to communicate to Brinks Home Security
- Low Bat = Panel low battery
- Low Bat 00 = Wireless keypad low battery
- Low Bat = 00 to 41 Wireless sensor low battery
- Msg = Voice message has been recorde, this is not a trouble
- Modem Comm = Remote access or download in progress, this is not a trouble
- NO AC = AC power failure