GC2 GoControl - Sensor Information Part 2
2GIG-PIR1-345 Motion Detector
Specifications
- 345 MHz sends supervisory signal every 70 minutes
- RF Range 100' from panel
- Operating temperature 32° F to 120° F standard installation
- Operating temperature 50° F to 90° F if set for pet immunity
Pet Immunity Setup
- Mount 7.5' from floor flat against wall with no downward tilt
- Do not face windows, tall furniture or stairs
- Set back jumper to low
- Set pet jumper by pet weight 33 pounds or 55 pounds
Testing
- Place magnet over arrow on side of motion for 3 seconds
- LED turns ON then flashes on movement
- Move in front of motion to test
- Test exits after 1 minute
2GIG-CO1-345 Carbon Monoxide Detector
Specifications
- Discontinued, replaced by 2GIG-CO3-345
- Sensor Life 6 years
- 345 MHz sends a supervisory signal every 70 minutes
- Trouble beeps can be silenced once for 7 minutes by pressing test button
- CR123A 3-Volt Lithium, 1 year estimated battery life
- RF Range up to 100' from panel
- Temperature Rating 32°F to 120°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
Installation
- Wall Mount at least 6" from ceiling or ceiling mounted at least 12 inches away from wall
- Install within 10' of sleeping areas
Testing
- Press and release Test button to test smoke sounder
- Press Test for 20 seconds to trigger smoke detector test to panel
Status LED
- Normal = Green flash every 12 seconds
- Alarm/Test = Red flash every 12 seconds, 4 sounder beeps
- Power Up = Red, yellow, and green LED's flash every 12 seconds, 1 chirp on power-up
- Trouble = Yellow flash every 6 seconds, 1 chirp every 45 seconds
- Low Battery = Yellow flash every 12
2GIG-CO3-345 Carbon Monoxide Detector
Specifications
- Carbon Monoxide Element Life 5 years
- 345 MHz sends a supervisory signal every 70 minutes
- RF Range up to 100' from panel
- 85 dB sounder
- Trouble beeps can be silenced once for 7 minutes by pressing test button
- CR123A 3-Volt Lithium, 1 year estimated battery life
- Temperature Rating 40°F to 100°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
Installation
- Wall Mount at least 6 inches from ceiling or ceiling mounted at least 12 inches away from wall
- Install within 10' of sleeping areas
Testing
- Press and release Test button to test smoke sounder
- Hold Test button 20 seconds to trigger smoke detector test to panel
Status LED
- Normal = Green flash every 12 seconds
- Alarm/Test = Red flash every 12 seconds, 4 sounder beeps
- Power Up = Red, yellow, and green LED's flash every 12 seconds, 1 chirp on power-up
- Trouble = Yellow flash every 6 seconds, 1 chirp every 45 seconds
- Low Battery = Yellow flash every 12 seconds, 1 chirp every 45 seconds
- Sensor End of Life = Red LED flashes every 10 seconds, 1 beep every 45 seconds
- Tamper = Red, yellow, and green flash every 12 seconds
2GIG-DW10-345 Door Sensor
Specifications
- 345 MHz sends a supervisory signal every 70 minutes
- 2 CR2032 3-Volt Lithium, 5 year estimated battery life
- RF Range up to 100' from panel
- Temperature Rating 32° F to 120° F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
2GIG-FF-345 FireFighter
Specifications
- Monitors existing hardwire Smoke Detectors
- Reports 30 seconds after smoke detector internal sounder activates
- Smoke Detectors must support UL Temporal 3 tones (3 beeps + pause + 3 beeps)
- 345 MHz sends a supervisory signal every 64 minutes
- CR123A 3-Volt Lithium battery, estimated life 5 years
- RF range up to 100' from panel
- Temperature Rating 32°F to 120°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
Installation
- Mount 6" with microphone facing smoke detector
Status LED
- Off = Normal
- Yellow Flash = Smoke Detector Sounder detected
- In Alarm = Red 3 seconds, then red flash
- Tamper = Red 3 seconds
- Power Up = Red flash + green flash
- Test = Green 3 seconds
2GIG-FT1-345 Flood Temp Sensor
Specifications
- Flood detection (using external probe): Activates 3 minutes after water detection
- High temperature alarm activates if 95 degrees for more than 5 minutes
- Low temperature alarm activates if 41 degrees or lower for more than 5 minutes
- 345 MHz sends a supervisory signal every 70 minutes
- 2 CR2032 3-Volt Lithium, 5 year estimated battery life
- RF Range up to 100' from panel
- Operating Temperature 32°F to 120°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
2GIG-GB1E-345 Glassbreak Detector
Specifications
- 345 MHz sends supervisory signal every 70 minutes
- 15' detection range
- 2 CR123A 3-Volt Lithium batteries, 5 year estimated battery life
- RF Range up to 100' from panel
- Operating temperature 32° F to 120° F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
Sensor Test
- Hold Test button for 2 seconds, red LED turns on, green LED blinks once
- Activate glassbreak tester by the window, green LED senses crash, red LED senses thud
- Sensor tests ends after 90 seconds
2GIG-Panic1-345 Remote Panic
Specifications
- Available as belt clip, watch, or pendant panic
- Hold button 3 to 4 seconds until LED turns on to activate
- Water resistant but not waterproof
- Can be used in the shower but not while in the bath or swimming
- CR2032 3-Volt Lithium, up to 3 year estimated battery life
- RF Range up to 100' from panel
- Operating temperature 32° F to 120° F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e